Ricoh Taurus-C1a Technical Bulletin page 58

Model:
Taurus-C1 / P1
<Main Machine \ Installation: Power Off \ Attention Light >
Screws for fixing the Attention Light were changed.
Before the Revision
1. The attention light is installed on the top rear edge
[A] with accessory screws (
<Main Machine \ Installation: Power Off \ Install Operation Panel: Standard
Installation >
Instructions were revised accordingly with the change in screw type.
Before the Revision
13. Fasten the back of the operation panel [A] to the
mounting bracket [B] (
• You will need a short screwdriver to attach the
screw at .
T
echnical
x3 M4x8).
x4).
B
ulletin
Date:
21-Oct-11
After the Revision
1. The attention light is installed on the top rear edge
[A] with accessory screws (
• The three screws must be removed from their
holes (these screws are not accessories).
After the Revision
13. Fasten the back of the operation panel [A] to the
mounting bracket [B] (
need a short screwdriver to attach the screw at
.
• You must use the M4x6 screws to fasten the
operation panel at this step. If you use the
longer screws (M4x8) they could touch and
damage the operation panel board.
PAGE: 10/58
No.:
RD074026
x3 M4x6).
x4 M4x6). You will