Model:
Taurus-C1 / P1
< Right Drawer \ LCIT Relay Sensor 2 >
Change in screw quantity
Before the Revision
2. Disconnect the sensor bracket [1] ( x1).
< Right Drawer \ Double-Feed Sensor 1 (LED) >
Change in screw quantity
Before the Revision
2. Remove bracket [1] (
< Right Drawer \ Double-Feed Sensor 2 (Receptor) >
Correction of screw quantity and type
Before the Revision
2. Disconnect the sensor bracket and remove the
sensor (
x2,
x1).
< Fusing Unit \ Before You Begin... >
"WARNING" note was added.
• The fusing unit can become very hot during normal operation.
•
Before removing the fusing unit, switch the machine off and wait at least 10 min. For the fusing unit
to cool so it can removed and handled safely.
T
echnical
x2).
B
ulletin
Date:
21-Oct-11
After the Revision
2. Disconnect the sensor bracket [1] (
After the Revision
2. Remove bracket [1] (
After the Revision
2. Disconnect the sensor bracket and remove the
sensor (
x1,
x1,
PAGE: 29/58
No.:
RD074026
x2).
x1).
x1).