Ricoh Taurus-C1a Technical Bulletin page 167

Model:
Taurus-C1a/C1b
For RK mode
[B]
9. Connect the accessory harness to the connector CN3 [A] on the interface board.
10. Connect the other end of the harness to the connector [B] on the control box
11. Fasten the connector as shown in the photo above.
For MF mode
12. Remove the controller board cover as described in your service manual in the section:
4. Replacement and Adjustments > Main Boards, HDD Units > Controller Board (GW),
NVRAM, Controller Board Fan
13. Connect the accessory harness to the connector [B] on the controller board [A].
T
echnical
[A]
[A]
B
ulletin
Date:
27-Feb-12
[B]
PAGE: 4/5
No.:
RD074046