Ricoh Taurus-C1a Technical Bulletin page 432

Model:
Taurus-C1a/C1b (D074/D075)
Solution
1. Open the front doors and remove the inner covers of the ITB unit.
2. Cheat the front door sensors by inserting a folded piece of paper, etc.
3. Turn the main switch on with the front doors open.
4. Check if the shaft circled in the photo below rotates during the initialization process.
If the shaft rotates:
If the shaft does not rotate: Go to step 5.
echnical
T B
The 2nd lift motor sensors could be dirty or the harnesses
connected to these sensors could be damaged. Check
the 2nd lift motor sensors and clean or replace them
according to the service manual, in section: 4.
Replacement and Adjustments > Image Transfer Belt
(ITB) Unit > 2nd Lift Motor Sensor 1 (K) and 2nd Lift Motor
Sensor 2 (K)
ulletin
Date:
24-Jan-14
PAGE: 2/3
No.:
RD074111