Table of Contents
Advertisement
Model:
Taurus-C1 (D074/D075)
Correction 2: Deleting the Developer Installing Procedure
Installation > Main Machine D074/D075 > Installation: Power On >
The Taurus was originally planned to be delivered from the factory with all 4 PCDUs
empty; not containing developer. In accordance with this initial plan, the service manual
instructs technicians to install developer when setting up a new machine.
However, the plans have changed and the PCDUs will be installed with the developer at
the production site.
Therefore, developer will not have to be installed upon new site installations.
Please correct the procedure described in this section as follows:
* Open Both Front Doors
Delete this procedure. The doors should remain closed.
* Connect Main Machine to Power Source and Power On
Execute this procedure. ("Door open" alert will not appear.)
* Install Developer
Delete this procedure.
* Do SP3025-001
Delete this procedure.
* Close Both Front Doors
Delete this procedure. (The doors are closed during the process.)
* Start Toner Fill
Execute this procedure as described in the service manual.
* Clean and Lubricate the Drums
Delete this procedure.
* Initialize TD Sensors
Delete this procedure.
* Initialize Process Control
Execute this procedure as described in the service manual.
* Exit SP Mode and Power Off
Execute this procedure as described in the service manual.
NOTE
The above changes apply only to the installation procedure when setting up
a new machine. Follow the original procedure (as described in the section
"Replacement and Adjustments > Photoconductor Development Unit (PCDU)
> Replacing Developer" of the service manual) when replacing the developer.
T
B
echnical
ulletin
Date:
22-Jun-2011
PAGE: 4/14
No.:
RD074015a
Advertisement
Chapters
Table of Contents
