Table of Contents
Advertisement
Model:
Taurus-C1/P1 (D074/D075/M044)
Subject: Addition of the PM item on the drum cleaning unit Prepared by: T. Komori
From:
1st Tech Service Sect., PP Tech Service Dept.
Classification:
The following part was added as a new PM part.
D0742510 CUSHION: CLEANING UNIT: ASS'Y
These cushions are attached to the back side of the drum cleaning unit, 2 cushions per
unit, as shown in the photo below to reduce the vibration generated from the unit,
which could cause short-interval banding.
IMPORTANT
These cushions do not have a PM counter but need to be replaced at 300Kp (135000m)
as they will wear over time. Combine the PM for this part with other components of the
drum cleaning unit that also require replacements at 300Kp.
How to attach the cushions
Clean the surface of the back side of the frame and attach the cushions D0742510 (2 pcs)
as shown below. To prevent toner from spilling, set the drum cleaning unit onto the
mainframe slide rails when attaching the cushions.
Cushion-Left
11mm
NOTE
If the drum cleaning unit is not attached with these cushions, implement the modification
with D0749904. For details, see RD074074.
echnical
T
Troubleshooting
Mechanical
Paper path
Product Safety
ulletin
B
Date:
13-Jun-12
Part information
Electrical
Transmit/receive
Other (
)
Cushion-Right
0 mm
PAGE: 1/2
No.:
RD074075
Action required
Service manual revision
Retrofit information
Tier 2
Advertisement
Chapters
Table of Contents
