Ricoh Taurus-C1a Technical Bulletin page 245

Model:
Taurus-C1a/C1b
Replacing the REAR Seal (D0743344: SEAL:DEVELOPMENT ROLLER:REAR)
1. Pull out the PCDU according to your service manual in the section:
4. Replacement and Adjustments > Common Procedures > Removing PCDUs
2. Remove the old seal [A] and clean the surface of the area where the seal was attached.
Note
The seal consists of two parts; the black part and the transparent part. (See the diagram
above.) Make sure to remove the whole seal.
echnical
T
[A]
ulletin
B
Date:
11-May-12
PAGE: 3/4
No.:
RD074063