Simotion D For Addon → Simatic S7; Common - Siemens SIMOTION D4x5-2 DP/PN Operating Instructions Manual

4.2 SIMOTION D for AddOn → SIMATIC S7
4.2.1

Common

Table 4-19 SIMOTION → SIMATIC S7, Common
PZD Signal name
1 ZSW1_Common_PLC
2 FAULT1
3
4 FAULT2
5
6 INFO_NO_AUTO_START
7
8 PARSET_OUT
9 IMPNT
10
11-12 -
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA
Unit Format Remark
- WORD Status word
see below, Table "ZSW1_Common_PLC"
- DWORD Error message 1
from AddOn technology, see Chapter Error list AddOn
(Page 374)
- DWORD Error message 2
from AddOn technology, see Chapter Error list AddOn
(Page 374)
- DWORD Information about SAM mode start
see below, Table "INFO_NO_AUTO_START"
1...99 SINT Parameter set confirmation
Confirmation of the number of the active parameter set.
1: Parameter set 1
2: Parameter set 2
3: Parameter set 3
4: Parameter set 4
mm DINT Current immersion point value
Either the internal or the external immersion point is
used as the current immersion point, depending on the
IMPNT_EXT_ACTIVE control bit.
The value is only meaningful when STS is selected.
Reserved
Communication interface to SIMATIC S7
4.2 SIMOTION D for AddOn → SIMATIC S7
97