Targets - Siemens SIMOTION D4x5-2 DP/PN Operating Instructions Manual

Bit Signal name
6 c_out_comm
7 d_out_comm
8 skewpos_ext
9 ska_in_comm
10 ska_out_comm
11 move_ska
12 reset_mdl
13 hold_trim_list
14-15 -
4.1.6

Targets

Table 4-12 SIMATIC S7 → SIMOTION D4x5-2 DP/PN, Targets
PZD Signal name
1 STW1_PLC_Targets
2 LANE_SHIP_LOAD
LANE_SHIP_UNLOAD
3 LEARN_POS_LANE
4-6 -
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA
Remark
0: No command
1: Control cylinder C with positive velocity
0: No command
1: Control cylinder D with positive velocity
0: No command
1: Set position for the electric skew drive is specified from an external source.
0: No command
1: Travel of the skew axis (negative velocity) via the internal setpoint generator
0: No command
1: Travel of the skew axis (positive velocity) via the internal setpoint generator
0: No command
Activation of the move command via the skew axis position control
0: No command
1: Resetting an internal oscillation model
0: No command
1: Hold the trim and list positions
Reserved
Unit Format Remark
- WORD Control word
(see below, Table STW1_PLC_Targets)
1...99 SINT Load lane number
This lane is used during loading.
1...99 SINT Unload lane number
This lane is used during unloading.
- SINT Save position
Save the current lane position.
Reserved
Communication interface to SIMATIC S7
4.1 SIMATIC S7 → SIMOTION D for AddOn
93