Other Errors 1 - Siemens SIMOTION D4x5-2 DP/PN Operating Instructions Manual

Alarm, error, and system messages
10.5 Error messages
10.5.3.6

Other errors 1

E50 (Bit 11) Velocity error, trolley
The trolley does not move, moves too fast or in the wrong direction. The error is triggered when:
● The output velocity is > 10% of the maximum velocity (P0) and the crane is not moving or
moving in the wrong direction
● The difference between the output velocity and the actual velocity > 20% of the maximum
velocity (P0) (e.g. defective drive)
The error appears with a delay of approx. 3 s. The error message is acknowledged when the
trolley moves.
The causes of these errors can be:
● Defective encoder
● Faulty connection to the drive
● Brake is still closed
The error is not signaled when the following error parameter of the drive (P161) is set to zero.
Error type:
Remedy:
E51 (Bit 11) Velocity error, hoist
The hoist does not move, moves too fast or in the wrong direction. The error is triggered when:
● The output velocity is > 10% of the maximum velocity (P40) and the crane is not moving or
moving in the wrong direction
● The difference between the output velocity and the actual velocity > 20% of the maximum
velocity (P40) (e.g. defective drive)
The error appears with a delay of approx. 3 s. The error message is acknowledged when the
hoist moves.
The causes of these errors can be:
● Defective encoder
● Faulty connection to the drive
● Brake is still closed
The error is not signaled when the following error parameter of the drive (P164) is set to zero.
Error type:
Remedy:
E52 – E57 reserved
E58 (Bit 21) Initial velocity to start semi-automatic mode (SAM)
The initial velocity when automatic travel starts in SAM mode is too high.
384
Error
Check actual velocity and output velocity
Error
Check actual velocity and output velocity
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA