Siemens SIMOTION D4x5-2 DP/PN Operating Instructions Manual page 272

SIMOCRANE CeCOMM commissioning and diagnostic program
8.5 Monitor (tab)
When a connection to the SIMOTION system has already been established, the following
functions are available to the user via the main menu (see the screenshots below, Figures
8-11, Editing AddOn parameters (Page 283), Sway Control monitors (Page 275))
1: Kinematics
2: PLC interface 1
3: Status of the drives
4: General bits
5: PLC interface 2
6: Semi-automatic mode (SAM)
7 - 9: TLS
B: Edit and display fixed obstacles
G: Display variable obstacles
F: Display error messages
H: Display error history
I: Call up commissioning menu
L: Fetch logger data
P: Edit parameters
V: Version and license information
X: Simulation of twistlock control
!: Initialization status of the parameter and language files
Y: Call up target generator menu
It is possible to switch between the individual menus directly by operating the appropriate key,
provided the key is not assigned in the active menu.
Note
The displayed menus, functions and dialogs can vary depending on the AddOn DCC library that
is in use.
272
SC integrated STS, GSU
Operating Instructions, 07/2019, A5E48271265B AA