Errors With Error Number (Id 1009-6115) - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
9.2.2

Errors with error number (ID 1009-6115)

Error Message
1009 Y position error
1010 X position error
1014 X fuse error
1015 Y fuse error
1045 No Z encoder
1049 Y PWM max error
1050 X PWM max error
1060 Sheet off error
1070 Tool swap error
2000 PG problem detected
194
Description
The head is obstructed and cannot move anymore. E.g.
due to a media crash or mechanical obstruction.
The media cannot be fed forward/backward. Because of a
media crash, too heavy media or mechanical obstruction.
Power supply problem

X fuse is broken

X motor problem

Power supply problem

Y fuse is broken

Y motor problem

Z encoder or flatcable is broken

There is too much force necessary to move the head left or
right.
There is too much force necessary to move the media back-
and/or forwards.
The front sensor is still covered after a sheet-off
Impossible to load/ unload the tool
Media is too short to perform a PG action
Solution
Remove the object blocking the
head and restart the cutter.
Remove the object blocking the grit
rolls and restart the cutter.
Contact an authorized Mutoh
technician
Contact an authorized Mutoh
technician
Contact an authorized Mutoh
technician
Remove the media or object
blocking the head from moving and
restart the cutter.
Remove the object blocking the grit
rolls and restart the cutter.
Check if the sheet-off system
Is the cutting blade still sharp?
Check for mechanical obstructions
Load a longer sheet
AP-75370 - Revision 1.1
Category
Fatal
error
Fatal
error
Fatal
error
Fatal
error
Fatal
error
Fatal
error
Fatal
error
Warning
Error
Warning