User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
9.1
Day-to-day use issues
In this section you will find a summary of problems that might occur during day-to-day use of your cutter and some hints how to determine the cause
of the problem.
9.1.1
Warning messages
Calibration warning
When starting up the Kona / Kona apparel, the machine is verifying the YZ profile and the EPOS calibration. If one of these two is not calibrated, a
message appears warning the user to perform these calibrations.
Note
Select the checkbox in case you do not want to see these messages when starting up. Be aware that this is not advised. If the
calibrations are not performed, the machine will work uncalibrated with the risk of loss in accuracy.
179
AP-75370 - Revision 1.1