MUTOH kona Series User Manual page 195

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
Error Message
Shift detection epos
6069
calibration
6098 EPOS calibration error
EPOS measurement is
6099
unstable
Bump problem machine
6100
width
195
Description
After performing an Epos calibration the cutter displays this
error in case it detects a shift compared to the last Epos
calibration
Could not calibrate the pen to laser distance
There is too much variation between the X and Y calibration
measurements
The cutter cannot finish the cutter width measurement
routine. This could be caused by a mechanical obstruction.
Solution
Contact an authorized Mutoh
technician
Make sure that the difference

between white and colour can
be recognized by the EPOS
sensor
Refer to
EPOS read on page 138
The media has not been weed

out (when asked on the display)
before the EPOS alignment
measurement
The laser is broken.

Is the media loaded correctly?

Refer to
Loading media on
page 51
Remove the media or object
blocking the head from moving and
restart the cutter.
AP-75370 - Revision 1.1
Category
Warning
Warning
Warning
Warning