User's Guide Kona / Kona apparel cutting plotter
Basics
3.4
Installing and replacing tools
3.4.1
Installing tools
On the first location (head assembly)
At the right-hand side of the cutter head, you find a pivoting mounting bracket. Open this
bracket to install a full range of cutting and drawing tools.
To do so, please follow the instructions mentioned below.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
On a Kona
On a Kona apparel
Step 7:
40
Power off the Kona / Kona apparel.
Make sure the pressure rollers are up.
Manually move the cutter head to the left.
Open the screw (1) to unlock the tool head-mounting bracket.
Hold back the clip (3) of the tool head and slide the tool into position, make sure the
tool collar fits into the groove just beneath the locking screw (2).
Fasten the screw (1) to secure the tool into position.
Power on the cutter and perform the EPOS alignment check to be sure the distance
between EPOS sensor and knife/pen point is set correctly. Otherwise, it might occur
that the data is cut with an offset.
Refer to
Epos on page 98
1
2
3
1
2
3
AP-75370 - Revision 1.1