Media Loading Procedure - MUTOH kona Series User Manual

Media loading procedure

Install the pre-printed media roll between the media holders. Position the roll and
Step 1:
tighten the media holders by fixing the thumb screws.
Guide the media as shown below:
Step 2:
Note
In case of working with curled media, refer to

Position the pressure rollers (1) so that every pressure roller faces a grit roll (2).
Step 3:
Each pressure roller has a tactile and audible click system to make it easier to
position them correctly.
Refer to
AP-75370 - Revision 1.1
Pressure roller positioning on page 51
1
2
z
User's Guide Kona / Kona apparel cutting plotter
Loading curled media on
Basics
3
page 69.
65