MUTOH kona Series User Manual page 126

User's Guide Kona / Kona apparel cutting plotter
Operation panel
Step 7:
Step 8:
Step 9:
Manual
When you want to start a contour cut job of which for example the bounding box is not printed
clearly, the automatic alignment option will not work. In this case the manual mode needs to
be chosen.
Start a manual contour cutting job as follows:
Step 1:
Step 2:
126
Press the start key.
The cutter will start scanning the bounding box and reading out the barcode.
As from the moment the barcode is recognized, the corresponding job is launched
from the Mutoh CutServer.
Press the following buttons in order:
Actions

Contour Cut

Manual

Decide whether the job loaded is a single or multi-frame contour cut.
AP-75370 - Revision 1.1