MUTOH kona Series User Manual page 123

Cutting plotters
Table of Contents

Advertisement

Move the penhead, using the jog keys, until the knife point is positioned above P1
Step 7:
and press OK when done.
P3
P4
The cutter will automatically feed the media the length set previously. Use the jog
Step 8:
keys to set the second corner more precisely if necessary.
Do this until you have selected all 4 corners in correct order (P1 – P2 – P3 – P4).
Step 9:
Insert the user selected tool when asked and press OK when done.
Step 10:
Note
This message is only displayed when the swap alert setting is set to ON.
Otherwise, the poster is cut through without this notification.
Refer to
The poster is trimmed according to the routine shown below:
Step 11:
3
After finalizing the poster trimming, insert the standard tool again and press OK.
Step 12:
Note
This message is only displayed when the swap alert setting is set to ON.
Refer to
AP-75370 - Revision 1.1
Y Width
Swap alert on page 90
4
6
1
Swap alert on page 90
User's Guide Kona / Kona apparel cutting plotter
P2
X Length
P1
5
2
Operation panel
4
123

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents