Cut Through - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Operation panel

Cut through

When all vector paths of your contour alignment are completed, single sticker samples (basic
shapes) are often to be isolated. Due to the intermittent or discontinued plotting of Mutoh's
supporting cut through technique, an extra protection of sticker drop-outs is guaranteed by
configuring your tool-up distance.
Refer to the Application Guide of the Kona / Kona apparel to know how to initiate a cut
through routine flawless.
It is however not easy to match an ideal tool configuration setup in which the media weakness
suffers not radically from the multiple cut through samples accomplished. Therefore a perfect
harmony between your tool down force and tool up distance needs to be synchronised.
Via this menu, you can set the desired cut through parameters.
Parameter
Tool
Velocity
Force
Test
Tool Up Distance
Tool Down Distance
Test
108
Description
Select which tool you want to use for the through cut procedure.
Default this is tool 2. But you are able to select another tool.
The speed of which the cut through routine is cut.
Default: 10 cm/s
The force on the tool during the cut through routine.
Default: 250 gram
Performs a small cutthrough test.
The quantity of media left uncut to hold the sticker fixed to the
media.
Default: 0,1 cm
The distance of cutting through the media.
Default: 10 cm
Performs a small cutthrough test.
1
2
AP-75370 - Revision 1.1