MUTOH kona Series User Manual page 202

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
Error Message Description
Thickness
All measured points of frame top vary too much from each other! This will
6241 problem
influence the accuracy of the cutting.
frame top
Thickness
Invalid thickness of P5 (right side of frame top). Thickness varies too much from
6242 problem
other top points! This will influence the accuracy of the cutting.
frame top
Thickness
Invalid thickness of P6 (top right of frame top). Thickness varies too much from
6243 problem
other top points! This will influence the accuracy of the cutting.
frame top
Thickness
Invalid thickness of P7 (top left side of frame top). Thickness varies too much from
6244 problem
other top points! This will influence the accuracy of the cutting.
frame top
Thickness
Invalid thickness of P8 (left side of top point). Thickness varies too much from
6245 problem
other top points! This will influence the accuracy of the cutting.
frame top
Thickness Invalid thickness of P5 and P8. Thickness of these points varies too much from
6246 problem each other AND varies also from P6 & P7! This will influence the accuracy of the
frame top cutting.
Thickness Invalid thickness of P6 and P7. Thickness of these points varies too much from
6247 problem each other AND varies also from P5 & P8! This will influence the accuracy of the
frame top cutting.
202
Solution
You can try to cut the job if you want
to. Perfect quality is not guaranteed.
What to check in case of bad quality:
Printer settings

RIP settings

Design

Refer to
Bounding box details on
page 152
AP-75370 - Revision 1.1
Category
Warning