MUTOH kona Series User Manual page 36

User's Guide Kona / Kona apparel cutting plotter
Basics
Step 5:
Step 6:
Step 7:
Step 8:
Step 9:
Step 10:
Note
After updating the new firmware, take a parameter backup. A new firmware

automatically leads to new internal parameters.
Refer to the application guide for more information.
36
Click Install to continue.
The program will extract the files.
Select the ComPort on which the cutter is connected and press Apply.
Refer to
Check COM port used on page 29
The PC will send and program the new firmware to the cutter.
The Kona / Kona apparel cutting plotter restarts automatically as soon as the
firmware is installed.
The new firmware is properly installed when you hear a beep.
AP-75370 - Revision 1.1