Remaining Time - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Basics
3.10

Remaining time

Once a job is sent to the cutter, the Kona / Kona apparel will process the data. While data is
being processed, the remaining time is increasing.
The moment the cutter receives data it will start processing and executing vectors. As long as
the processing of data takes place, the remaining time may increase. Once the processing
stops, the remaining vectors will be executed and the remaining time will start to decrease.
Be aware that a tool change command in a file blocks the further analyses of vector
commands until the tool change is done. Therefore the remaining time is either the time until
job end or until the next tool change.
When pressing the pause button, the remaining time will be paused as well.
74 AP-75370 - Revision 1.1