Protocol - MUTOH kona Series User Manual

4.2.3 Settings 3/3

Protocol

This menu incorporates Emulation and VS/ZF/AS.
To set these parameters press the following buttons in order:
Step 1:
Emulation




VS/ZF/AS

Several cutting software packages enable the user to send speed, force and acceleration
commands to the cutter. The cutter can be set up to accept or ignore these commands.
Note
When VS and ZF commands are sent and accepted, they override the speed,

force and acceleration settings the user has set from the cutter operation
panel. When the VS and ZF commands are ignored, the cutter always uses the
settings, which are set-up from the cutter operation panel.
AP-75370 - Revision 1.1
Settings
2x next page
Protocol
Emulation
VS/ZF/AS
Choose between accept and ignore and confirm with

User's Guide Kona / Kona apparel cutting plotter
Operation panel
4
115