User's Guide Kona / Kona apparel cutting plotter
Through cutting
7.4
Poster trimming workflow
After printing some posters, it is possible to use the Kona / Kona apparel cutting plotter to trim
the posters afterwards. Do this as follows:
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
168
Load the poster in the cutter.
Install a knife at through cut depth.
Make your personal settings regarding the cut through feature.
Tool
Velocity
Force
Tool up distance
Tool down distance
Refer to
Through cut settings on page 165
parameters.
Press the following buttons in order:
Actions
Cut Through
Trim poster
Set the approximate length and width of the poster.
Press the next key.
for all details on how to change the
AP-75370 - Revision 1.1