Error Messages; Recoverable Error Messages With No Error Id Number - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
9.2

Error messages

Note
If an error appears, the cutter will make a beeping sound. It is possible to

switch off this sound by simply touching the screen.
9.2.1

Recoverable error messages with no error ID number

During a cutting, measuring or other sequence, it might be possible that one of the below errors occur. Please find a list below with all the possible
errors which can be solved yourself, without any need of an intervention by an authorized Mutoh technician.
Error
EPOS calibration
error <RETRY>
EPOS problem: PG
problem occurred
192
Cause
EPOS sensor goes in error during the EPOS
calibration.
When there has been executed a PG
command between 2 segments or at the start
of a new job, this error can occur. This can
be caused by:
Media is too short

Job has been interrupted by the user

A movement cannot be

because of mechanical failures.
Solution
Try again or reboot and try again.

Contact an Authorized Mutoh Technician

if the error remains.
Check the media size.

Reboot the machine.

performed
Refer to ...
AP-75370 - Revision 1.1