MUTOH kona Series User Manual page 97

Up velocity
Set the cutting speed according to the application (cut through, contour cutting).
The speed can be set as well on the cutter panel as in the cut software. When the speed is
set in the software, the panel speed is overruled when the function VS/ZF/AS is enabled (by
default).
Y-direction
(maximum tool up speed - 100 cm/s)
Note that there is also a throughcut speed. This speed can be set in the separate Cut Through
menu.
Up Height
This setting gives you the opportunity to set the tool height above the media during operation.
For example: The drag knife touches the uneven media during the up movements. Increase
the tool Up Height to prevent these media collisions.
Press the following buttons in order to open the Up Height window:




AP-75370 - Revision 1.1
X-direction
(tool down speed)
Settings
Tool
Next page
Up Height
The Up Height window opens.

Set the preferred height and confirm with

User's Guide Kona / Kona apparel cutting plotter
Operation panel
4
97