Replace Cutting Mat - MUTOH kona Series User Manual

3.4.4

Replace cutting mat

Please follow the procedure below to replace the cutting mat.
Draw a line with a small pen in front of the cutting mat and remove the worn cutting
Step 1:
mat.
Clean the platen with isopropanol.
Step 2:
Install the new cutting mat in the same position as the old one.
Step 3:
Note
Be aware that there is a small groove and hole on the Kona apparel. Do not tape

a cutting mat over this hole or groove.
These are both necessary when working with tools in the second location.
If you notice cutting errors after replacing the cutting mat, it might be necessary to
Step 4:
contact an authorized Mutoh technician to perform a Y-Z profile measurement.
AP-75370 - Revision 1.1
User's Guide Kona / Kona apparel cutting plotter
Kona
Basics
Kona apparel
3
45