Trouble Shooting
7.2 Operational Problems
Some mechanical problems or failure during operation will cause some problems. If the
problem still exists after the recommended actions have been taken, have your cutting
plotter serviced.
7.2.1 LCM Error Messages
The error messages shown on the LCM present the problem first, and followed by recommended
actions.
Error; Check Media
Or Drum Or X Motor
Error; Check Media
Or Y Motor
Error;Check Carriag
Sensor Or VC Motor
Graph Was Clipped
Data In Buffer
This message indicates that there might be a
problem on the X axis (the media feeding
direction). Check if the drum is working well and if
the media is well loaded. Correct the problem and
re-power on to reboot system.
This message indicates that there might be an
obstruction to carriage relating to a problem on the Y
axis (the carriage moving direction). Correct the
problem and re-power on to reboot system .
This message indicates that the blade up/down
sensor malfunction. Re-power on to re-boot system.
If the problem still exists, find a serviceman.
This message indicates that the cutting exceeds the
cutting limit. Reload larger media or re-scale the plot
to a smaller size; then press the key followed by the
display of LCM to continue.
64
ValueCut USER MANUAL
V5a 2015 Jan