Operational Problems; Lcm Error Messages - MUTOH ValueCut II VC2-600 User Manual

Trouble Shooting

7.2 Operational Problems

Some mechanical problems or failure during operation will cause some problems. If the problem still
exists after the recommended actions have been taken, have your cutting plotter serviced.

7.2.1 LCM Error Messages

The error messages shown on the LCM present the problem first, and followed by recommended
actions.
This message indicates that there might be a problem on the X
axis (the media feeding direction). Check if the drum is working
well and if the media is well loaded. Correct the problem and
re-power on to reboot system.
This message indicates that there might be an obstruction to
carriage relating to a problem on the Y axis (the carriage
moving direction). Correct the problem and re-power on to
reboot system .
This message indicates that the blade up/down sensor
malfunction. Re-power on to re-boot system. If the problem still
exists, find a serviceman.
This message indicates that the cutting exceeds the cutting limit.
Reload larger media or re-scale the plot to a smaller size; then
press the key followed by the display of LCM to continue.
This message indicates that it couldn't detect the registration mark
properly by AAS auto-detection. Check the registration mark
quality is fine and also check the image scale setting is matching
to the media.
70
ValueCut USER MANUAL
VC2E-A-00