MUTOH kona Series User Manual page 159

When the cutter establishes a slight difference between the thicknesses of the frame in one or
more corners, a re-measuring is performed at the respective side of the frame but slightly
higher or lower. If there is still dissimilarity, a warning message is displayed on the panel and
a cross is cut in the lower right corner.
Refer to
Contourcutting errors and warnings (ID 6201-6271) on page 197
Note
The same principle of scanning is also used on the top and centre of the

bounding box. Due to the use of this measurement system it is possible to
measure bounding boxes with a small print step error.
AP-75370 - Revision 1.1
Situation 2 = Both sides detected (4 points)
3
2
Situation 3
1st scan > both sides detected (2 points)
feed of media to start second fast scan
2nd scan > bottom and side of frame detected (4 points)
3'
2'
1
User's Guide Kona / Kona apparel cutting plotter
1'
Contour cutting
4
1
scan 1
4'
2
scan 2
scan 1
159
6