Settings 1/3; Tool - MUTOH kona Series User Manual

4.2.1

Settings 1/3

Tool

Select this menu to select the:
Type of tool on page 83

Velocity on page 84

Force on page 85

Offset on page 87

Swap alert on page 90

Management on page 91

Up velocity on page 97

Up Height on page 97

Type of tool
Set the type of the active tool. Depending on the installed tool, an offset needs to be taken
into account.
Refer to
Offset on page 87
Refer to
Replace cutter blade on page 42
Set the tool as follows:
Press the following buttons in order:
Step 1:



AP-75370 - Revision 1.1
for all information about the offset principle.
Settings
Tool
Type
User's Guide Kona / Kona apparel cutting plotter
for more information on how to replace the blade.
Operation panel
4
83