Contour Cut - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Operation panel
Step 13:

Contour cut

Refer to the Kona / Kona apparel Application Guide for detailed information about
contour cutting, and how to set your cutter and software.
Refer to the chapter
choose and the bounding box specifications.
Automatic
When performing a single or multi-frame contour cut job, start the job via the Go button on
Mutoh's CutServer. It is also possible to launch the job directly from the cutter itself, only on
the condition that the cutter is connected with Mutoh's CutServer. In fact, this function
replaces the Go button.
Start a single or multi-frame contour cutting job as follows:
Step 1:
124
Gently push out the poster.
Contour cutting on page 145
Press the following buttons in order:
Actions

Contour Cut

Automatic

to know which alignment method to
AP-75370 - Revision 1.1