Some Parts Of The Design Are Not Well Cut; The Output Is 2,5 X Too Large Or 2,5 X Too Small - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
9.1.8

Some parts of the design are not well cut.

Check whether the knife tip is not clogged with material residues.

Examine the knife blade with a magnifier to see if the tip is not damaged or broken.

Perform the offset adjustment routine to check cutting quality.

Perform the test cut and check its quality.

Perform the EPOS alignment test.

9.1.9

The output is 2,5 x too large or 2,5 x too small

The cutter is using the wrong step adjust. Please refer to chapter 4 "Program Step", to correct the step adjust and try again. As an alternative

solution, you can also choose to change the step adjust in your software. Both settings should be matched to each other.
191 AP-75370 - Revision 1.1