MUTOH kona Series User Manual page 169

Move the penhead using the jog keys until the knife point is positioned above P1
Step 7:
and press OK when done.
P3
P4
The cutter will automatically feed the media the length set previously. Use the jog
Step 8:
keys to set the second corner more precisely if necessary.
Do this until you have selected all 4 corners in correct order (P1 – P2 – P3 – P4).
Step 9:
Insert the through cut tool when asked and press OK when done.
Step 10:
Note
This message is only displayed when the swap alert setting is set to ON.

Otherwise, the poster is cut through without this notification.
Refer to
The poster is trimmed according to the routine shown below:
Step 11:
3
After finalizing the trimming of the poster, insert the standard tool again and press
Step 12:
OK.
Note
This message is only displayed when the swap alert setting is set to ON.

Refer to
AP-75370 - Revision 1.1
Y Width
Toolswap settings on page 164
4 6
1
Toolswap settings on page 164
User's Guide Kona / Kona apparel cutting plotter
P2
X Length
P1
5
2
Through cutting
7
169