User's Guide Kona / Kona apparel cutting plotter
Maintenance
8.1.3
Cleaning the cutter blade
Use following procedure to remove small media particles in the base part of the cutting blade
holder.
Standard knife holder
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Knife holder with nonius
Step 1:
Step 2:
Step 3:
174
Hold the body (2) into one hand and unscrew the base part (1)
Remove the spring (3) and the cutting blade (4).
Blow away media particles accumulated in the top of the base part.
Remove the spring from the cutting blade and remove any residual material from
the blade tip
Place the spring back over the cutting blade and tightly screw the base part on the
body.
Take the body into one hand and remove the base part.
Blow away the media particles accumulated in the top of the base part.
Remove any residual material from the blade tip.
AP-75370 - Revision 1.1