Smoothing - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Operation panel
4.2.2 Settings 2/3

Smoothing

Smoothing can be enabled or disabled. Depending on your choice, cutting of blunt angles is
dealt with differently by the cutter.
If the complementary angle between two consecutive vectors A & B is larger than the
smoothing angle, the cutter will slow down and cut a sharp corner (1). If the angle is smaller,
the cutter will maintain its speed and cut a rounded corner (2). The optimum smoothing angle
is calculated internally. When smoothing is DISABLED all corners are cut sharply.
Enable or disable the smoothing as follows:
Step 1:
Step 2:
Note
It is advised to enable the smooting feature.

110
Press the following buttons in order:
Settings

Next page

Smoothing

Choose between ON (recommended) or OFF and confirm with
AP-75370 - Revision 1.1