Job Focus; Auto Shuffle - MUTOH kona Series User Manual

User's Guide Kona / Kona apparel cutting plotter
Operation panel

Job focus

A lot of advanced cutting settings are made in the background without any need of
intervention by the end-user. Select by means of the table below the correct job focus.
Step 1:
Step 2:
Job Focus
Accuracy
Speed

Auto shuffle

After an automatic sheet-off, it is possible to let the cutter shuffle the set load length or to hold
until further action is required.
Refer to
Enable or disable this function as follows:
Step 1:
Step 2:
112
Press the following buttons in order:
Settings

Next page

Job Focus

Choose between accuracy and speed and confirm with
Description
Give in some speed, but gain quality.
Give in some quality, but gain speed.
Load length on page 106
Press the following buttons in order:
Settings

Next page

AutoShuffle

Choose between ON and OFF and confirm with
AP-75370 - Revision 1.1