User's Guide Kona / Kona apparel cutting plotter
Maintenance
8.1
Cleaning and daily maintenance
Your cutting plotter, knives and pens will work better and last longer if you keep them clean
and perform a few simple daily maintenance tasks.
Note
Before performing cleaning and daily maintenance, please power OFF the unit
and remove the power cable.
8.1.1
Cleaning the grit roll
Cleaning the grit rolls consists out of two parts.
Part 1 is the place where the pressure rollers (1) press the media firmly against the grit rolls
(2). For this reason it is possible that, after some time, the friction drive rolls (2) become
clogged with accumulated residue from cutting media. This can cause slippage of the
material, resulting in inaccurate cuts or incorrect vinyl transport. Therefore it is a good habit to
clean the drive rolls regularly. To do this you can use a brush and rotate the rolls manually to
make sure that they are thoroughly cleaned.
Part 2 is the place where the grit roll is touching the inside bearing. After a while there might
be a trace on the grit roll.
Clean this trace with a polyknit wiper.
172
1
2
AP-75370 - Revision 1.1