MUTOH kona Series User Manual page 34

User's Guide Kona / Kona apparel cutting plotter
Basics
Step 9:
Step 10:
Step 11:
Step 12:
Step 13:
Step 14:
Note
After updating the new firmware, take a parameter backup. A new firmware

automatically leads to new internal parameters.
Refer to the application guide for more information.
Note
It is not advised to downgrade to lower firmware versions. If downgrading the

firmware, a correct functioning cutter is no longer guaranteed with the current
settings.
34
Click Install to continue.
The program will extract the files.
Select the ComPort on which the cutter is connected and press Apply.
Refer to
Check COM port used on page 29
The PC will send and program the new firmware to the cutter.
The Kona / Kona apparel cutting plotter will restart automatically as soon as the
firmware has been installed.
The new firmware has been installed properly when you hear a beep.
Reset the user machine defaults and restore the backup from the previous

version. e.g. restore parameter backup taken on FW 1.0.0.
AP-75370 - Revision 1.1