MUTOH kona Series User Manual page 67

Select the media measure method.
Step 4:
Refer to
Load the media properly:
Step 5:




Make sure the media is cut off straight at the front to avoid media initialization
Step 6:
mismatches.
Rise the lever as soon as all the correct settings have been made.
Step 7:
Refer to
Refer to
Note
Make sure not to get stuck on the pressure roller lever, this could damage your

clothes.
Note
The head will move fast over the media. Be careful not to pinch your fingers

during this action.
AP-75370 - Revision 1.1
Load mode on page 104
It is best to hold the front edge of the media in the middle with one hand and with
the other hand the roll itself.
While holding the roll firmly into position, pull the front edge of the media forward
so that there is an even tension across the whole width of the roll (= equal
tension method)
Do NOT use the drilled holes to align a roll of media! Rolls can only be correctly
installed using the equal tension method.
The holes will help you monitoring if the media is not meandering too much.
Load length on page 106
Auto shuffle on page 112
User's Guide Kona / Kona apparel cutting plotter
Basics
3
Indicates the max
working width when
working with a
Kona Apparel
67