MUTOH kona Series User Manual page 201

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
Error Message Description
Thickness
All measured points of frame bottom vary too much from each other! This will
6231 problem
influence the accuracy of the cutting.
frame bottom
Thickness
Invalid thickness of P1 (right side of frame bottom). Thickness varies too much
6232 problem
from other bottom points! This will influence the accuracy of the cutting.
frame bottom
Thickness
Invalid thickness of P2 (bottom right of frame bottom). Thickness varies too much
6233 problem
from other bottom points! This will influence the accuracy of the cutting.
frame bottom
Thickness
Invalid thickness of P3 (bottom left side of frame bottom). Thickness varies too
6234 problem
much from other bottom points! This will influence the accuracy of the cutting.
frame bottom
Thickness
Invalid thickness of P4 (left side of bottom point). Thickness varies too much from
6235 problem
other bottom points! This will influence the accuracy of the cutting.
frame bottom
Thickness Invalid thickness of P1 and P4. Thickness of these points varies too much from
6236 problem each other AND varies also from P2 & P3! This will influence the accuracy of the
frame bottom cutting.
Thickness Invalid thickness of P2 and P3. Thickness of these points varies too much from
6237 problem each other AND varies also from P1 & P4! This will influence the accuracy of the
frame bottom cutting.
201
Solution
You can try to cut the job if you want
to. Perfect quality is not guaranteed.
What to check in case of bad quality:
Printer settings

RIP settings

Design

Refer to
Bounding box details on
page 152
AP-75370 - Revision 1.1
Category
Warning