Did You Know; Print And Cut Workflow; You Can Easily Rip And Print Your Postnet Bar Code Contour Job With A 3Rd Party Rip And Contour Cut It With Easysign.122 - MUTOH Kona Application Manual

Application Guide Kona / Kona apparel
Hints, tips and tricks
7.3

Did you know

7.3.1

Print and cut workflow

Installing the EasySIGN Mutoh Edition of NCD does not allow you to RIP and print your
tasks. To make sure a bounding box frame and bar code are collected during RIPing and
printing in your 3rd party RIP, an export all (*.eps) can be done in EasySIGN.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Step 8:
122
You can easily RIP and print your POSTNET bar code
contour job with a 3rd party RIP and contour cut it with
EasySIGN.
Create your design.
Open / import your design in EasySIGN.
Enable your bar code alignment system (cropmark settings).
Export your task (in EPS format) from EasySIGN (disable your Print and Cut lines if
required).
Rip and print your task in a 3rd party RIP.
Plot (hot folder CutServer).
Verify your Mutoh CutServer settings.
Press "Go".
AP-75381 - Revision 1.3