Origin - MUTOH kona Series User Manual

Origin

Note
Be aware that this is the standard Origin setting. There is also the possibility to

customize the origin. For more information concerning the customized origin
refer to
Set the cutting starting position (origin) as follows:
Please make sure to load media. If not, the positioning calculation is based on
Step 1:
previously installed media.
Press the following buttons in order:
Step 2:



Select the origin position and confirm with
Step 3:


Note
The tip of the knife will stand directly above the selected origin.

Note
The point of view of the above picture is when standing in front of the cutter.

AP-75370 - Revision 1.1
Origin on page 121
Settings
Next page
Origin
Center
Lower right (default)
REAR
CENTER
FRONT
MediaWidth
User's Guide Kona / Kona apparel cutting plotter
.
L RIGHT
Operation panel
4
113