Table of Contents
Advertisement
8.2 ERROR MESSAGES
8.2.1
Recoverable errors messages
During a cutting, measuring or other sequence, it might be possible that one of the below errors occur. Please find an alphabetical list below with all the possible
errors which can be solved yourself, without any need of an intervention by an Authorized Mutoh Technician.
Error
EPOS calibration error
EPOS sensor goes in error during the EPOS
►
calibration.
<RETRY>
EPOS problem:
The distance between the reference box and
►
Media problem occured
end of roll is too short
Much print distortion.
When measuring the four points of a reference
►
To continue: V
box and the cutter establishes a distortion (this
To abort: X
means the box is not a perfect rectangle due
to print deformation, or not between the
margins), the cutter will beep and displays an
error message (Much print distortion)
The cutter will cut a little cross in the lower
►
right corner to remind you to its bad print
quality in case of bad contour cutting. You can
continue or abort the job.
EPOS problem:
When there has been executed a PG command
PG problem occurred
between 2 segments or at the start of a new job,
this error can occur. This can be caused by:
►
►
►
Cause
Media is too short
Job has been interrupted by the user
A movement cannot be performed because of
mechanical failures.
88
User's Guide SC-PRO Cutting Plotter
CHAPTER 8: TROUBLESHOOTING
Solution
1. Try again or reboot and try again.
2. Contact an Authorized Mutoh
Technician if the error remains.
1. Reprint the job with the correct
specifications.
2. Stick a piece of white vinyl to the end
of the roll
1. Reprint the job.
1. Check the media size.
2. Reboot the machine.
AP-75280 – Rev. 1.1
Refer to chapter in manual
► Contourcutting ► Square details
Advertisement
Table of Contents
