MUTOH kona Series User Manual page 193

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
Error
The plot data is out
of limit and is
clipped to hardclip
region
Unable to show
point
EPOS problem: No
EPOS reference
found
193
Cause
The data sent to the cutter is larger than

the position between the first and last
pressure roller.
There is an error during the switch from

the cutter knife to the laser or vice versa.
If the cutting head is located at the end of

a paper during the switch, this error can
occur also.
It might be possible that the bounding box

cannot be found.
The EPOS sensor is broken

Solution
Load appropriate media.

Reposition pressure rollers.

Redesign your job.

Try again or reboot and try again.

Contact an authorized Mutoh technician if

the error remains.
Select the correct file in the Mutoh

CutServer and start the job manually
(send EPOS job)
Make sure that the printed bounding box

is made within the specifications. (print
the file once again with a thicker bounding
box, e.g. 5 mm or more)
Be sure that the contour cutting box is

located in between the two outer pressure
rollers.
Be sure that the media is loaded straight.

Contact an authorized Mutoh technician

to replace the sensor
Refer to ...
Refer to
Loading media on
page 51
Refer to Application Guide
Refer to
Bounding box details
on page 152
AP-75370 - Revision 1.1