Loading Sheet Media; Configuration To Start From; Media Loading Procedure - MUTOH kona Series User Manual

3.7.3

Loading sheet media

Configuration to start from

The pressure rollers are raised.

The rear media collection bag is open and empty.

Open the front media collection bag when the cutting job is smaller than 4m.

Close the front media collection bag when the cutting job is larger than 4m.

Remove the media support rollers.


Media loading procedure

Guide the media under the pressure rollers at the front of the cutter.
Step 1:
Note
In case of working with curled media, refer to

Position the pressure rollers (1) so that every pressure roller faces a grit roll (2).
Step 2:
Each pressure roller has a tactile and audible click system which makes it easier to
position them correctly.
Refer to
AP-75370 - Revision 1.1
Pressure roller positioning on page 51
1
2
z
User's Guide Kona / Kona apparel cutting plotter
Loading curled media on
Basics
3
page 69.
55