MUTOH kona Series User Manual page 90

User's Guide Kona / Kona apparel cutting plotter
Operation panel
Swap alert
It is possible to configure multiple tools. The Kona / Kona apparel has an integrated swap
alert system. This system gives you a warning when a tool change is needed.
You are able to enable or disable this swap alert system.
Press the following buttons in order:
Make your preferred choice:
On: If a tool change is requested in a plot file, you will hear a beep and a message is

shown which tool to insert and on which location.
Off: If a tool change is requested in a plot file, you get no alert. The machine continues

cutting and has changed automatically from one tool to another.
Note
In some conditions, even when the setting is put to off, an alert has to be given:

90
Settings

Tool

next page

Swap alert

A new tool with a different type on the same location.

No tool loaded yet on the target location.

Jump back to a location and the tool type is different before and after the jump.

AP-75370 - Revision 1.1