MUTOH kona Series User Manual page 103

Accuracy
Use this setting to lower the amount of EPOS bounding box measurement warnings. For
example, you know that some step adjust distortion or spray around the bounding box lines
may occur, you can choose to lower the accuracy to a lower range. By lowering it, the
bounding box measurement will issue less warnings (or none), when there is a print distortion
detected.
Important
The lower the selected accuracy, the lower the expected cur accuracy.

Change the EPOS accuracy setting as follows:




Note
In case the cutter measures a bounding box distortion or deviation that falls in

a lower range than the selected accuracy, a message screen appears asking if
you want to lower the accuracy range.
For example, the EPOS Accuracy level was set to High, but the Kona / Kona
apparel measures a print distortion that falls in the Middle range. In this case a
warning message will appear. If selecting Yes, the EPOS Accuracy setting is
adapted to the new value.
AP-75370 - Revision 1.1
Settings
Epos
Accuracy
Change the setting to High, Middle or Low and confirm by pressing
User's Guide Kona / Kona apparel cutting plotter
Operation panel
4
103