MUTOH kona Series User Manual page 203

User's Guide Kona / Kona apparel cutting plotter
Troubleshooting
Error Message Description
Thickness
Thickness of centre points (P9 & P10) differs too much from each other AND
6251 problem
differs also from bottom points P1 and P4.
frame centre
Thickness
Invalid thickness of P9 (right centre point). Thickness varies too much from P10!
6252 problem
This will influence the accuracy of the cutting.
frame centre
Thickness
Invalid thickness of P10 (left centre point). Thickness varies too much from P9!
6253 problem
This will influence the accuracy of the cutting.
frame centre
Thickness
Thickness of centre points (P11 & P12) differs too much from each other AND
6254 problem
differs also from bottom points P1 and P4.
frame centre
Thickness
Invalid thickness of P11 (right centre point). Thickness varies too much from P12!
6255 problem
This will influence the accuracy of the cutting.
frame centre
Thickness
Invalid thickness of P12 (left centre point). Thickness varies too much from P11!
6256 problem
This will influence the accuracy of the cutting.
frame centre
203
Solution
You can try to cut the job if you want
to. Perfect quality is not guaranteed.
What to check in case of bad quality:
Printer settings

RIP settings

Design

Refer to
Bounding box details on
page 152
AP-75370 - Revision 1.1
Category
Warning