MUTOH kona Series User Manual page 109

Follow the procedure below to make the appropriate settings:
Press the following buttons in order:
Step 1:





Enter the desired values and confirm with
Step 2:
Press the test key to verify the quality of the through cutting settings.
Step 3:
Set the values for the tool up and tool down distance.
Step 4:


Enter the desired values and confirm with
Step 5:
Press the test key to verify the quality of the through cutting settings.
Step 6:
Check if it is easy to push out the cut patterns. If not, try to increase the force and
Step 7:
knife depth or to decrease the tool down distance.
Refer to
Be sure to perform a sheet-off after the test because the pushed-out squares/circles
Step 8:
will uncover the paper sensor which could lead to an error.
AP-75370 - Revision 1.1
Settings
Cut through
Click tool
Select the tool you want to use and confirm with
Set the values for the velocity and force.
Go to the next sub page
Select Up Dist. and/or Down. Dist.
and
Force on page 85
User's Guide Kona / Kona apparel cutting plotter
Adjusting the knife depth on page 48
Operation panel
4
109